TACT  SWITCH  SPECIFICATION( 輕 觸 開 關(guān) 說 明 書 )

6.3 Environmental 環(huán)境

Item 項 目

Test Condition試驗條件

Requirements 要求

6.3.1.

Resistance to Low Temperatures

耐低溫

Following the test set forth below the sample shall be left in mormal temperature and humidity conditions for one hour before measurements are made:

樣品按下列條件進行耐低溫試驗，測試前在正常溫度和濕度條例上放置 1 小時

(1) Temperature: -30±2℃      溫度

(2) Time: 96 hours               時間

(3) Water drops shall be removed   擦除水珠

Item 6.1

Item6.2.1

Item6.2.2

6.3.2.

Heat Resistance

耐 熱

Following the test set forth below the sample shall be left in normal temperature and humidity conditions for one hour before measurements are made: 樣品按下列條件進行耐熱試驗，測試前在正常溫度和濕度條件下放置 1 小時

(1) Temperature:240±5℃      溫度

(2)        Time: 96 hours      時間

Item 6.1

Item6.2.1

Item6.2.2

6.3.3.

Moisture

Resistance

耐潮濕

Following the test set forth below the sample shall be left in normal temperature and humidity conditions for one hour before measurements are made: 樣品按下列條件進行耐潮濕試驗，測試前在正常溫度和濕度條件下放置 1 小時

(1)       Temperature: 60±2℃      溫度

(2) Relative humidity: 90 to 95%    相對濕度

(3)              Time: 96 hours      時間

(4) Water drops shall be removed   擦除水珠

Item 6.1

Item6.2.1

Item6.2.2

6.3.4.

Temperature

Cycling

溫度循環(huán)

www.km5858.com

Following the test set forth below the sample shall be left in normal temperature and humidity conditions for one hour before measurements are made. 樣品按下列條件進行溫度循環(huán)試驗，測試前在正常溫度和濕度條件下放置 1 小時

During this test, water drops shall be removed,

在試驗期間，擦除水珠。

Item 6.1

Item6.2.1

Item6.2.2

APPD

CHKD

DSGD

PARTNO:        

5/10